The morning after hail, you walk out and the yard looks like it got sandblasted. Leaves are shredded. The truck has a couple new dimples. You look up at the roof and it mostly looks the same, which is exactly why good photos matter. The first person to touch the roof after a storm might be an adjuster, a roofer, or your own well-meaning neighbor with a ladder. Once someone starts moving things, sweeping granules, or popping a cap off a vent, the story changes.
We like homeowners to document what’s there before anything gets disturbed. Not because you need to become an “inspector”, but because hail damage is often small, scattered, and easy to miss until the light hits it right. In Rowlett TX, storms can throw mixed sizes, so you can have bruised shingles on one slope, bent metal on another, and a gutter that took the worst of it. Your job is simple: capture clear, dated proof of condition.
Start with wide shots that prove the date, the roof, and the slopes
Before you zoom in on anything, get the boring photos. They are the ones that tie everything together later.
Stand back and shoot all four sides of the house, corner to corner, so the roof planes are obvious. Get at least one photo that includes a street sign or house number, plus the roofline. Then take a set from each side showing the slope facing that direction. Hail doesn’t always hit evenly. A south-facing slope can look fine while the west slope shows most of the impact because the storm came in at an angle.
If you can safely do it from the ground, take a photo up each valley line and each ridge line. Valleys are where water concentrates, and hail can crack shingles along the cut edges in a valley faster than you’d expect.
Two practical specifics:
- Turn on the timestamp in your phone camera settings.
- If you use a ladder, keep it 3 feet above the eave and do not step onto the roof if you are not trained. Photos from the ground and ladder line are still useful.
Shingles: capture hail hits, granule loss, and the “bruise” without touching it
Shingle damage is where people lose the paper trail, usually by rubbing a spot to “see it better.” Don’t. A bruised shingle can look like nothing until it’s compressed, and then it looks like you created it.
From the ladder line or a safe roof edge, shoot straight-on photos of each roof plane. Then zoom in and take close-ups of anything that looks like:
- A dark circular spot (often 1 to 2 inches across) where granules are crushed.
- A shiny patch where asphalt is exposed.
- A torn mat line, especially on laminated architectural shingles where the top layer is thicker.
If you can get close without disturbing anything, take one photo with a reference object for size, like a coin, but do not press it into the shingle. Hold it next to the mark.
Also photograph the gutters right below the eave. Heavy granules in the trough after a hail event can support what happened on the shingles above.
If your roof is more than 15 years old, take a few extra photos of general condition too. Age-related brittleness changes how hail presents, and your “before” condition matters. (If you’re trying to sort out what age and weather do to shingles around here, how Rowlett weather impacts your roof’s lifespan lays it out plainly.)
Soft metals take a beating: vents, pipe boots, turbine tops, and flashing edges
Hail tells on itself when it hits soft metal. This is why we always want photos of roof penetrations and any exposed flashing.
Look for dents on:
- Box vents and ridge vent end caps.
- Turtle vents (low-profile static vents).
- Turbine vents (the spinning type).
- Metal collars around plumbing vent pipes.
If you have rubber pipe boots, get photos of the rubber too. After impact and heat cycles, rubber can split at the top edge of the cone, and the split may be 1/4 inch long at first. Catch it early.
Flashing photos matter most at transitions. Take clear shots of step flashing along chimneys and sidewalls, and counterflashing if you have masonry. On many homes, the step flashing is hidden under siding or brick trim, but the edges and corners still show. Hail can bend the kickout flashing at the bottom of a wall, and that’s a classic leak point in the next hard rain. (This ties in with where Rowlett roof leaks start before you ever see a water stain.)
One more specific: if you have painted metal, photograph chipped paint. Bare metal oxidizes fast in Texas heat, and that changes what repairs look like later.
Gutters, downspouts, drip edge, and fascia: document dents and alignment changes
Gutters are easy to photograph and they are often the clearest storm evidence. Walk the whole perimeter.
Take long shots down the gutter runs to show sagging or new dips. Then take close-ups every few feet where you see dings. Aluminum K-style gutters dent with hail, and the dents usually line up on the side facing the storm.
Check and photograph:
- Downspouts, especially the elbows. Those thin curves take hits.
- The drip edge along the eave and rake. If the edge is bent up, water can wick under shingles in a driving rain. (If you want the why behind that, why Rowlett roof edges fail first is worth a read.)
- Fascia boards and soffit panels. Vinyl soffit can crack at the locking channel. Aluminum fascia can show “peppering” dents.
If you have gutter guards, shoot them too. Some snap-in screens get popped loose by impact, and then they rattle in wind and dump water behind the gutter.
A helpful measurement: take one photo showing the gutter seam or an end cap. Those are common leak spots later, and a close-up of the joint, before anyone reseals it, keeps the record clean.
Siding, window trim, screens, and paint: catch collateral damage that points back to the roof
Hail damage is not always “roof only.” If you are documenting Rowlett TX hail damage roof photos for a claim file, the exterior walls help tell the story of direction and intensity.
Walk the elevations that faced the storm. Photograph:
- Dents in aluminum window wraps and corner trim.
- Cracks in vinyl siding panels, often along the lower edge where the panel is thinnest.
- Chipped paint on fascia, trim, and patio covers.
- Torn window screens and bent screen frames.
Solar screens deserve their own set of photos. The frames are usually lightweight aluminum, and hail can bow them or pop fasteners. Get one full-frame photo of each affected screen, then a close-up of any dent or ripped mesh.
If you have fiber cement siding, look for surface chipping and edge bruising. If you have wood siding, look for fresh bare spots where the finish got knocked off. Those spots take on water, then swell and split.
Don’t “wash it off” first. Water hides impact marks and can smear chalking paint, which changes what the photo shows.
Inside the house: photograph stains, wet insulation, and attic clues before they dry
Interior photos are time-sensitive. A ceiling spot that looks small at 9 a.m. can spread by afternoon, then fade as it dries and leaves a ring.
Start with a wide shot that shows where you are in the room. Then take a close-up of the stain. If you have a tape measure handy, include it in the frame to show size without touching the ceiling.
Go to the attic if you can do it safely. Bring a flashlight. Photograph:
- Wet or darkened roof decking. Most homes have 7/16 inch OSB or 1/2 inch plywood, and wet wood shows a darker field and swollen edges.
- Wet insulation. Fiberglass batts slump. Blown-in cellulose mats down.
- Nail tips and fasteners. Water often tracks along a nail shank and drips from a single point.
Also take a photo of any daylight you can see at a vent or around a penetration. You are not trying to prove a “hole.” You are documenting conditions.
One more: if you have a bathroom fan duct that terminates near the roof deck, photograph it. Condensation and storm leaks can look similar, and clear attic photos help sort that out later.
Keep the evidence clean: file names, no repairs yet, and a simple shot list
The best photo set is the one that stays organized and believable.
Take photos before anyone:
- Sweeps valleys.
- Rakes granules out of gutters.
- Reseals a flashing joint with roof cement.
- Swaps a vent cap.
Even “temporary” work changes the surface. If you have active leaking, you can still protect the inside. Use a bucket, towels, and plastic sheeting. Photograph the leak first, then mitigate.
A simple system works:
A shot list we like homeowners to follow
- 4 sides of the house, wide.
- One photo per slope, then one per ridge and valley you can see.
- Close-ups of 10 to 20 shingle marks per affected slope (more is fine if they are clear).
- Every vent type you have, at least one close-up each.
- 3 to 5 gutter close-ups per side that got hit.
- Any interior stain, wide and close.
Rename files the same day. “West slope closeup 01” beats “IMG_4837.” Email the set to yourself so the timestamps are preserved if your phone gets replaced.
Key Takeaways
- Turn on camera timestamps and start with wide shots that show the house number and each roof slope.
- Photograph shingle bruises and granule loss without rubbing or pressing on the marks.
- Get close-ups of soft metals, including box vents, turbine tops, pipe boots, and step flashing corners.
- Walk the gutters and downspouts, shoot long runs for sagging, then close-ups of dents and seams.
- Interior stains and attic wet spots change fast, photograph them the same day before they dry.
Conclusion
After hail, the roof can look “fine” from the driveway and still be compromised in all the little places that keep water out, shingle mat, flashing corners, vent collars, gutter seams. Good photos taken early keep the facts straight. They also make the next steps calmer because everyone is looking at the same record.
If you want us to look things over, we will. We can compare what your photos show with what we find on the roof, then lay out what needs repair versus what needs replacement, and what should be handled on the gutters, siding, paint, and screens so the whole exterior goes back together the right way. Keep the roof untouched until somebody qualified is ready to document it properly. (If you’re still on the fence about getting someone out after a storm, do I need a roof inspection after a Rowlett storm answers it straight. If you’re dealing with hail specifically, roof repair after a hail storm is the next step.)
External references: NOAA’s National Weather Service is a solid source for storm and hail reporting, OSHA’s ladder safety guidance is worth following before you climb, and the National Roofing Contractors Association has general roofing and maintenance resources that line up with how roofs actually fail and get repaired.
